X2e Extended Molded Arms - Coming soon

tripple 1

Well-known member
Messages
51
Likes
0
The drive line pins will not fit into the stock cups with the toobz over them
Owell not the end of the world
 

TheSpike

Well-known member
Messages
65
Likes
0
Location
Dubai
I have IRP tie rods in the front and the complete Phatdad drive shaft set in the rear.
Any idea which parts I need to upgrade additional to fit the extended arms?
I presume the drive shafts will be too short, so are there right length Phatdad available, also do the IRP tie rods extend long enough to fit?
Sry, too many questions ;)
 
Thread starter #49

KraKenRC

Well-known member
Messages
2,039
Likes
0
Location
Temecula, CA
I have IRP tie rods in the front and the complete Phatdad drive shaft set in the rear.
Any idea which parts I need to upgrade additional to fit the extended arms?
I presume the drive shafts will be too short, so are there right length Phatdad available, also do the IRP tie rods extend long enough to fit?
Sry, too many questions ;)
Here what's available -

Turnbuckles:
IRP extended - http://www.davesmotors.com/tr330_2.html
Kraken RC- http://www.davesmotors.com/kraken-r...e-extended-a-arms-for-hpi-baja-5b-5sc-5t.html

Dogbones set-up:

Phatdad but has been out of stock for a while - http://www.davesmotors.com/tt365FLM_2.html

Kraken RC (uses stock cups, NOT SC ones) http://www.davesmotors.com/kraken-r...it-for-x2e-a-arms-for-hpi-baja-5b-5sc-5t.html

FLM - If you are running new 2014 or have a Baja SC cups/driveline, use FLM's extended for SC - http://www.davesmotors.com/fastlane...iveshafts-for-fastlane-extended-arm-kits.html

Uber RC extended - http://www.davesmotors.com/tt686.html
 
Last edited:

tripple 1

Well-known member
Messages
51
Likes
0
Will the drive line work with the flm tt208 set of cups??..i hope so because they dont fit my toobz on my 5b??
Thanks
And could u pm the deal on the x5 cage
Thanks
Jamie
 
Thread starter #52

KraKenRC

Well-known member
Messages
2,039
Likes
0
Location
Temecula, CA
Will the drive line work with the flm tt208 set of cups??..i hope so because they dont fit my toobz on my 5b??
Thanks
And could u pm the deal on the x5 cage
Thanks
Jamie

Yes should fit. Don't forget you can just change out the pins which is probably easier and cheaper to do.
 

Foxracing

Well-known member
Messages
158
Likes
0
Location
North of Green Bay WI
I find a problem not sure if its me or not but the rear lower a-arms rub hardcore on a turtle racing quick diff. The raised middle part hit by one lower screws on it will take pictures if needed.
 

tripple 1

Well-known member
Messages
51
Likes
0
Ill look at mine in the am...im about 99%..sure theres no rubbing on mine...there very smooth. .but ill double check in am
 
Top