SlammerRC's Trevor Simpson Engine Damn

SlammerRC

Well-known member
Media
Messages
1,233
Location
Marble Falls, Texas
We have had several requests for a SlammerRC Engine Damn for the Trevor Simpson motor.
You asked for them so here they are.

We understand the TS motors come with a "screen" that you glue into the housing however, this "screen" does not keep the grass from building up between the "screen" and the inside of the engine case housing.
Our TS Engine Damn helps keep the grass out of the engine case housing all together yet still allowing air to flow into the housing, then through the "screen".

For you Trevor Simpson fans we have designed the following:
-------------------------------------------------------
The new Trevor Simpson Engine Damn 1s are at DDM

Engine Damn Installation Instructions



Fits a Trevor Simpson motor, using a Chung Yang clutch housing.
Part Number: ED-TS-C

For more photos

-------------------------------------------------------
The new Trevor Simpson Engine Damn 2s are at DDM

Engine Damn Installation Instructions




Fits a Trevor Simpson motor, using a Zenoah clutch housing.
Part Number: ED-TS-Z

For more photos

Thank you, your requests are always welcomed! ...Ron

.
 
Last edited:

SlammerRC

Well-known member
Media
Messages
1,233
Location
Marble Falls, Texas
Treat the turtle housing as stock housing specs.
You would use the Part Number: ED-TS-C Fits a Trevor Simpson motor, using a Chung Yang clutch housing.

OR DDM part number tr132
 

SlammerRC

Well-known member
Media
Messages
1,233
Location
Marble Falls, Texas
Is that the one you made a while back from the material I sent you?

If so, I need to send you a new one. Do you have that motor installed yet??
 
Last edited:
Top