Naxz
Well-known member
- Messages
- 176
- Location
- Winnipeg, Canada
- Thread starter
- #1
Just got my Modified RC front light mounts and wondering how did you guys install yours with RPM arms.
Pics request
- Thread starter Naxz
- Start date
.:Andy:.
Well-known member
- Messages
- 231
- Location
- Sydney, Australia
It doesnt fit :*( Same thing happened with me.
So i just got a hack saw and cut a bit of the arm off... yeh it may make the arm weaker and more vulnerable, but i havent had any problems since doing this, and i can't run my car without the lights
So i just got a hack saw and cut a bit of the arm off... yeh it may make the arm weaker and more vulnerable, but i havent had any problems since doing this, and i can't run my car without the lights
boarder4twnty
Well-known member
- Messages
- 7,320
- Location
- Minden, NV
I used a bench grinder and clearanced then enough to fit the mount in, I'll see if I have a pic...
boarder4twnty
Well-known member
- Messages
- 7,320
- Location
- Minden, NV
Modified RC
Well-known member
- Messages
- 8,238
- Location
- NW Indiana
Yes you will need to trim the front inside of the upper A-arm. It's easily done with a dremmel tool or you can shave it off little by little with an exacto knife.
The RPM arms are still plenty strong after removing the material, you only need to remove .160 inch or about 4mm
The RPM arms are still plenty strong after removing the material, you only need to remove .160 inch or about 4mm