5b Protecta Rear Skid Plate

Thread starter #1

neeper

New member
Messages
2
Likes
0
I bought a new Protecta Rear Skid Plate for my 5B off of Ebay but didn't get any of the hardware. I tried searching the web for a list of the mounting hardware parts but no luck.

Can anyone here give me a list of things I need for mounting the Protecta Skid Plate on my 5B?

Any help would be greatly appreciated.
 
Thread starter #3

neeper

New member
Messages
2
Likes
0
Can someone please give me a complete list of mounting hardware so I can get them from my local hobby store?
 

Tbredon

Well-known member
Messages
2,197
Likes
0
Location
Canton,OH
I believe it uses two of those locking nuts mentioned above, three half inch 4mm counter sunk screws and one lock nut. Google "Protecta skid plate installation" for directions.
 

recce01

Well-known member
Messages
863
Likes
0
Location
So Cal, USA
The list is as follows
2 "pem nuts" as linked by Animal or this number to be exact...

McMaster Carr part number
99437A155
2- Pem nuts from above
2- 5mm X 8mm countersink bolts
1- 5mm X 10mm countersink bolt
1- 5mm washer
1- 5mm nylock nut
1- 5mm hex head bolt X 10mm for installation of Pem nuts
 

Modified RC

Well-known member
Messages
8,238
Likes
0
Location
NW Indiana

Monsterman

MonstermanHBF
Staff member
Moderator
Media
Messages
38,470
Likes
2
Location
Pittsburgh Pa
Yes it will fit I have one installed on the Modified Chassis you will just need to remove some material off the Modified Chassis to get it to sit flush.. Make sure you have a dremel tool.
 

Monsterman

MonstermanHBF
Staff member
Moderator
Media
Messages
38,470
Likes
2
Location
Pittsburgh Pa
Top