Recent content by 65BAJA

Any chance of Turtle pull starts going on special?

Is this beast still around?

Any pictures of the rebuild?

What is the best insert to run with the slicks?

I switched to the RCR brakes myself. They are worlds better than stock.

Just put mine back together and ran it for the first time in 3 years. Need tires and new air filter foam. Oh...and fresh gas that isn't also 4 years old. I was surprised it ran at all.

Back together and running. Need some fresh gas and a good carb tune.

For the last 3 years my 5B has been in pieces on my bench. I think it's time to get it moving again. Going to need new tires for the front at least but I think that is about it. This forum seems to be a bit ah...less active now vs 3 years ago. Did everyone sell off their rigs?

I haven't run mine in a while but I've run it at Prairie City a few times.

I haven't run mine in about 2-3 years. Motor started dieing out after 30 seconds of running. Pulled the motor changed the carb, changed the gaskets, changed the gas, changed the plug. Then finally I just gave up. Read a post about a year later about someone having the same issues. Turns out it...

Just wondering if anyone is running the WT990 on a stock 26 Fuelie? Would there be any gains? Better low end? More overall power? Was it any more difficult to start?

Currently I'm running a stock 26 Fuelie with hi flow can and a shreadstack. If I keep the hi flow can exhaust will I see much performance improvement with the 28.5cc race ported top end?

The area I run in has some really hard pack terrain with a light dusting on top. I was wondering if maybe a lower RPM clutch spring might reduce the tire spin a little. Let the clutch engage before the motor is making too much power to spin the tires. Just a thought. Or maybe someone has some...

Got my kill switch, Outerwares, and chassis brace. Thanks DDM!

I want one.