I bought some V2 extenders (fronts went on smooth, for the most part
Threw on some stuff working front to back, and then went to but the rear extenders on; My problem is...
They didnt fit. If i try to to put them on the right way, they dont fit, but if i put the threaded portion first, it slides on no issue. The original SS wheel hex slides on no issue, and the threaded first slides on no issue. If i try to put them on (either, on either side) the proper way, they dont even get past the very tip.
I thought about lube, but its not that its a tight fit, it just doesnt fit at all. Most of the stuff i found was the old V1 or after they had the retrofit kit, or just general questions and no one had this issue.
Am i doing it wrong? I would assume you would just slip it over, slap the pin through and install as the original hex would. So the question is,
Are they just a manufacturer defect? i find it hard to believe both would not fit. I tried both on both sides and neither slid on, even with force.